There may be many reasons why your Proton Saga BLM doesn't start when you turn the ignition key, but here is one solution which worked for me.
Disclaimer: My Proton Saga BLM is an automatic transmission, 1.3 liter model and registered in 2010.
The key unit of the Proton Saga BLM is made of plastic housing, and it houses many important electrical components inside. Many years of constant use (i.e. gripping the plastic housing and turning the key to start the engine) result in the plastic housing cracking and giving way. One of the effects of wear and tear is a hole forming in the plastic housing, near the metal part of the key.
![]() |
Everything looks normal from the top |
![]() |
On closer inspection, the plastic housing has a huge crack, exposing the insides |
Next to this hole lies a sensor which is crucial to starting the car. The sensor is rectangular and measures approximately 1cm by 0.5cm. Through wear and tear, if the hole becomes big enough, or if the plastic housing becomes wobbly or nonfitting, chances are the sensor may fall out of the plastic housing. This results in the car being unable to start even if you insert the ignition key and turn it to start the engine.
![]() |
Plastic housing opened, showing position of sensor within it |
![]() |
Plastic housing opened, with sensor removed |
Conclusion.
If you observe your key's plastic housing has become loose or cracked, chances are the sensor has fallen out. Open the plastic casing to confirm that the sensor has fallen out. Try to recall where you last applied pressure to the plastic housing. Usually it would be the last time you started or stopped the car... in which case, check your driver-side car mat. Replace the sensor, and tape the plastic housing nicely together.
Thank you!!
ReplyDeleteYou're welcome Chewy :)
DeleteThis was really helpful! Thank you so much!
ReplyDeleteGlad you found it helpful Sara!
DeleteWHAT IF THE SENSOR IS LOST?
ReplyDeleteYou ded.
DeleteFor real tho. Replace it, which will cost you.
Deleteso unlucky..i lost it just now... where can i replace? original proton workshop?Do u around how much?
DeleteYou can try CCM motor workshop in Sentul. He did it for my car as well when I lost the sensor as the key holder fell apart. Jalan Sentul near post office. His name is Ah kit and he has the programmer.
Deletethank you for helping. around how much u did?
Deletei lost my sensor...can i start engine without sensor
Deletethanks a lot.
ReplyDeleteThis post works! Proton Thanks! Proton Saga
ReplyDeleteMy Saga faced this problem 2-3 times in a month (car cannot start & it sounds like coughing). I replaced the starter 3 times already. But till today, the 'cough' sound still appear. Is it because of the sensor?
ReplyDelete